Solidworks Drawing Dimension Slot Length -

The tight key is a connection component fitting into the slot of the shaft and in the hub with torque being transmitted only by the sides of keys The key slots

○ Dimension values in drawing refer to the full size of the object 6 Dimensioning slots Page 30 Ahmed Kovacevic, City University London Design

slot beton888 The follwing shall be observed where specifying millimeter dimensions used on drawings Metric Dimension Notes: Drawing must state the units used and

slot slang The two types, the tee slot and the dovetail slot, are shown in Figure 4-5 The drawing shows the dimensions of the threaded part but other information